|
|
Post by Chris_Sav on Aug 20, 2012 19:44:22 GMT
Recover started
|
|
|
|
Post by Chris_Sav on Aug 21, 2012 14:07:01 GMT
 Can't see any problems here (touch wood), apart from the cup rings were held in by reinforced concrete or similar ;D >:(, had to carefully chip the surround loose on each one before I could tap the ring out. |
|
|
|
Post by Chris_Sav on Aug 24, 2012 19:34:06 GMT
Recover finished for 232B, no major problems with this one, usual longitudinal wedges and clock shortened to just under 17 minutes.
Sav
|
|
|
|
Post by Chris_Sav on Oct 29, 2012 9:12:48 GMT
Catastrophic failure of the back wall on this table, with the top of the back wall splitting off and the hinges coming away. Taken to Savland for repair and rehinging on the leg posts.
This is the third problem with the back wall where the support for the weight of the slate is focused on too small screws in too small an area of the wall. The result is the wall splits.
Sav
|
|
|
|
Post by Chris_Sav on Oct 30, 2012 12:48:05 GMT
232B where the back has split due to the poor support and standing the table on end, which we have to do for transport.  232b on the operating table  The threatening amount of wear there is to the corners on some where the tables are being dragged around without protection under them. This is entirely preventable. I may try and prtect this one with some brass strip, but have to be careful about damaging floors instead! The gap in the beading is where I am going to rehinge it.  |
|
|
|
Post by Chris_Sav on Mar 30, 2015 8:49:05 GMT
Front right leg thread needs a leg with a good thread on it offered to the socket as the socket is a little worn.
Also cloth quite badly scored from D towards left hand fifty.
|
|
|
|
Post by Chris_Sav on Mar 30, 2017 8:05:20 GMT
I have the clock has failed on this table with the non return ratchet that drives the ticker mechanism failing. I have hopefully been able to source a replacement part.
Clock also needs at least four bushes replacing.
|
|
|
|
Post by Chris_Sav on Apr 5, 2017 7:48:43 GMT
The repaired ticker unit, lovely work!! Four bushes replaced and the ratchet/clutch spring replaced. Under test now.  |
|
