|
Post by Pingpong - Mike on Apr 27, 2020 16:40:34 GMT
Hi I have just joined the site waiting for approval, but in the mean time I am after some help please.
I am restoring a Jelkes Bar Billiards table about 1940. I have almost finished but I have a problem fitting some new orange plastic ring holes I purchased with the new felt.
The holes on the table are 2 and half inches wide 64mm and that is the outer diameter of the rings not allowing for the felt, I have tried sanding the plastic rings down a little on the edge
but they are way too tight still. I can only get them in half way by banging them with no felt. Any help would be grateful. Thanks Mike
|
|
|
Post by bryans666 on Apr 27, 2020 22:32:03 GMT
Best person to talk to is Chris Saville who has had the right size pockets made
|
|
|
Post by Chris_Sav on Apr 28, 2020 8:11:46 GMT
Hi Mike and welcome,
I've authorised tour account so I suggest you look in the members section on pocket rings. There are many variations.
The only ones on the market I have seen are crap and nothing like the originals and too big as you have found out.
I believe I have a set or two of some that are nearly as good as the originals but I won't be using them so you could have them for the postage. You'll have to be patient as I have not been out for six weeks and won't be until covid is over as my decrepitude and underlying health problems mean I am vulnerable.
If you are even more patient then take a look at the thread on 3D printed rings, but that seems to have come to a halt temporarily hopefully.
|
|
|
Post by pingpong on Apr 28, 2020 12:25:36 GMT
Hi Chris
Many thanks for the warm welcome to the site, I am glad I found it. Yes I would love to get some pocket rings from you and pay you for them please.
I could get them picked up by FedEx if that is convenient with you.
Please let me know.
Thanks again Mike
|
|
|
Post by Chris_Sav on Apr 28, 2020 13:29:46 GMT
We have several sets of rings but I'm not prepared to let any original ones go before the 3D project in on stream. As mentioned I have a set as in Taffy's post below; barbilliards.proboards.com/thread/13385/replacement-billiard-table-pocket-rings?page=2Mine are in brown and 63mm outside diameter. If you want to organise pick-up then fine by me. They are a part of my league's stock and we have thousands in the bank so don't need anything for them. I would rather they were put to good use. PM me if you want to take this further please.
|
|